Templates for silver earrings :
They’re pretty simple, but I wanted to share how you make them and k through the steps. So stick around if that sounds like something you’re interested in, and let’s get right to it. All of their templates book of sometimes it’s just paper cutouts, and sometimes it’s the basic things. So a sample of it has all your measurements and sizes of all the metals you’ve used. Because if you don’t have the piece, sometimes you need to remember what’s it 0.6 or keep it all in here. The samples of pieces of chain and ring sizing, so today you’re going to be making these lunar silver earrings, so I want to check the size. So they are 18 miles across, and then they’ve got a little slit that is 0.9 mil Deep.
So you’re going to use their template draws thingy bobby here to draw that onto the metal. So let you go and grab that, and You didn’t write the metal thickness down here. But you know that’s it so in case in the future. Remember, 0.6 is a suitable thickness for silver earrings metal. So let’s grab some sheets; the stash from when you left bought a big chunk of biodegradable, right? so they will need to draw on there with a scribe if you are going to use 18 wide here around. If you always use it in the corner because you’d want to save materials and costly things like silver.
So it’s always good to use just what you need and needs to make two pairs of these. If you are going to do four of these, always make sure that you leave maybe about one or two miles between each Shape. You’re drawing because, obviously, you want to cut about a mil over the size when you’re cutting. If you want, you can file down to the size, and then your Shape will be correct.
Metal for silver earrings :
Because especially with a circle, you want it to be as perfect as possible, so you need to be able to see the line. So they want to leave a bit of space for the saw blade, and what silver earrings metal the saw blade gets rid of, so you got enough space if you cut in between here. Imagine cutting there, and there will be enough space to file down to there, so you’ll do a little bit around the edge of all of these. before you start cutting, go to what you did here so on the back of your hold the back doesn’t matter on the one side of your metal when you get It.
Because it doesn’t have any sizes on this piece didn’t so draw it over it and just wrote 0.6. So that if you only have a piece, see the size of it. You don’t get confused, so let’s cut these out; see here. Now, if you see the blade wouldn’t go any further, what you’re going to do is very carefully take it out, and because it’s pretty OK there, you’re just going to loosen it like that, and then you’re going to put it back in.
They tighten it again, push against it and tighten. So it makes excellent guitar string sound, and then you’re going to come in from this side so you can see, so the way you cut it out is you left about just around a mil Bigger. So please do your best and then file the rest, so don’t stress too much about it.